SRAM Bleeding Edge bleed port plug - where to find?

[Wayne]

I noticed the port plug is missing on my front SRAM caliper. These are surprisingly hard to find. Any ideas where I can buy a few?

 

[ctechbob]

Is it just a rubber plug to keep junk from getting in there?

 

[Wayne]

Is it just a rubber plug to keep junk from getting in there?

Yes, it's a pretty simple plug. If I could find one that is generic, I'd use that.

 

[Azjeff]

Did you try Universalcycles.com?

https://www.universalcycles.com/shopping/index.php?category=5543

Edit: My buddy from Pa is coming this weekend I think his S-Works Stumpy runs SRAM stuff, I'll steal one for you.

 

[ctechbob]

Or have a friend with a 3d Printer print one out of TPU.

 

[Wayne]

Did you try Universalcycles.com?

https://www.universalcycles.com/shopping/index.php?category=5543

They had a lot of parts, but not the plugs.

Edit: My buddy from Pa is coming this weekend I think his S-Works Stumpy runs SRAM stuff, I'll steal one for you.

 

[Wayne]

Or have a friend with a 3d Printer print one out of TPU.

I wish I knew someone who does 3D printing.

 

[ctechbob]

I wish I knew someone who does 3D printing.

My TPU doesn't print that great but I can do them if you can let me know the diameter and depth you need.

I was going to ask you anyways if you'd ever bought the quick connects, I have some covers for the male ends I printed up I was going to send you.

 

[Wayne]

My TPU doesn't print that great but I can do them if you can let me know the diameter and depth you need.

This is what they look like:

 

[Wayne]

I was going to ask you anyways if you'd ever bought the quick connects, I have some covers for the male ends I printed up I was going to send you.

I haven't yet, but likely will.