Azjeff
Well-known member
I've known about this problem for a while just didn't get to it. This trip it almost failed so time to fix it. This is the drawer in the bathroom vanity over the water heater. Typical el cheapo slides as expected but the method of attaching the back ends of the slides just makes you shake your head. A 1x 2" piece of pine was stapled to the 1x1 that holds up the countertop. (I put the screws in to get home.) A strip of 1/2" plywood was attached with 1 screw to make a tee that the back ends of the slides were screwed to. Photo 2 of the vertical piece after I'd removed the slides and the setup on the bench. The slides fell apart when I took the drawer out. Replaced with full extension soft close slides attached to 3/4" plywood that was screwed/glued to the paneling.
Realize this trailer is a 2017 so this was when GD had the better than average rep and Covid can't be blamed.
The junk slides that the bearings rolled out of.
Not moving now.
Realize this trailer is a 2017 so this was when GD had the better than average rep and Covid can't be blamed.
The junk slides that the bearings rolled out of.
Not moving now.